Tri-Oxy REFRESH Manual

Creatrix Solutions

$0.00
SKU:
1995

Tri-Oxy® REFRESH Assembly Instructions

Pour degassing granules into the container on top of the pre-installed FDA approved stainless steel mesh filter; then screw on the cap and leave in place until it is time to replace the degassing material. Degassing material needs to be replaced when it no longer destructs ozone gas, which could take 5 to 10 years depending on how often you ozonate water with the Tri-Oxy® REFRESH. Connect the silicone tubing to the FDA approved degasser size of your choice (0.5 micron or 50-60 micron), then connect the other end of the silicone tube onto the container bottom male barb fitting. Screw the Tri-Oxy® REFRESH assembly onto the glass jar, filled with water. Connect a silicone tube from an ozone generator to the top cap male barb fitting. Turn on ozone generator to ozonate water or other preferred liquid. When done ozonating your preferred liquid, empty the liquid and screw the Tri-Oxy® REFRESH assembly back onto the glass jar and run the ozone generator to blow out water from the diffuser. After each use blow out the diffuser with ozone gas, or with your mouth and dry so the diffuser pores do not clog.

Ozonate the liquid for approximately 1 minute per ounce of water. If using the .5 micron diffuser you can reduce that time by 50%.

tri-oxy-refresh-assembly-1.jpg tri-oxy-refresh-assembly-2.jpg 

tri-oxy-refresh-assembly-3.jpg