Enema Fix Manual

Creatrix Solutions


Enema Fix Parts & Assembly Instructions 

Plastic Bottle

Tips and Short Straw

There are two draw straws, including a long one for the glass jar. ONLY use the draw straws inside of the jar. DO NOT use the vaginal or rectal tip inside the jar. 

Bottle, Jar, and Pump

 To assemble: Hold the screw cap with one hand and turn the pump plunger/spout counterclockwise with the other hand to open. 

How to Assemble How to Assemble

How to Assemble

The plunger will pop up, like a shampoo bottle dispenser, once you rotate it far enough. It takes about nine counterclockwise rotations to unscrew.

Next, attach the longest draw straw to the inside bottom on the pump with the diagonally cut end pointed toward the bottom of the jar to siphon up the liquid. Add the finger grip by inserting the draw straw through the center ring of the finger grip. The finger grip should be positioned so the underside contours allow for your fingers to hold the whole Enema Fix while pumping.  See the picture of the assembled Enema Fix for the correct finger grip position. Securely screw the pump assembly onto the jar adapter.  Attach the tubing adapter to the pump spigot and make sure to tightly push on this connection. 

WARNING: Do not insert the tip adapter without first attaching the tip. Only TIPS should be inserted into the body.

You might need to use a hair dryer to heat the tubing adapter to completely push it on the spigot. If so, let it cool down and shrink to give a leak tight seal. Add your preferred tip onto the end of the tubing adapter.  Fill the jar with your preferred enema solution and screw on the jar adapter with pump assembly, making sure the gasket is in between the jar and the adapter.  Once you confirm all the connections are securely tightened, hold the jar handle with one hand, and vigorously pump the plunger up and down with the other hand. Keep two fingers on the finger grip and your thumb on the pump plunger and apply pressure while pumping to push out the air and prime the tubing with liquid.  You will waste a small amount of fluid to prime the tubing.  Then slowly insert the tip into the anus, with optional lubrication, and gently pump liquid inside your rectum. 

Intermittently, I massage up my left side (ascending colon), horizontally across my abdomen (transverse colon), and down my right side (descending colon) to allow the fluid to travel throughout the bowel. Then, I take a 7–10-minute shower and when I get a strong urge to eliminate, I step out to sit on the toilet.  I use a squatty potty stool while on the toilet and massage my abdomen in the reverse direction.  Afterwards, I jump back in the shower and repeat the process.

Enema Fix Kit

The female opening of the silicone tube fits onto the male tip of the tube adapter. The male tip of the adapter inserts into the female opening of the desired tip.

WARNING: Please follow the instructions to avoid dropping the glass jar and breaking it. This can happen if the pump is not completely screwed on to the adapter and the jar is separated from the pump. Double check the connection, so you know you can safely hold the pump and jar by the finger rest while pumping. Keep the jar on the shower floor once you have dispensed half the liquid. The hose is extra-long, so you can even pump the liquid with the jar on the shower floor.  Either way, putting or keeping the jar on the floor or a wide bench seat will minimize accidental breakage.